Week of Events
Machining 100 – Intro To Machining
Machining 100 – Intro To Machining
Billy will give you a basic introduction to the machining area. This class will begin with a tour of the machining area with a, in-depth discussion of each tool, it’s uses, proper procedures, and safety. At the end of this class, all participating members will be authorized to use the drill press, box pan brake, handtools, and the horizontal bandsaw.
Woodworking 101
Woodworking 101
This class will cover topics related to safe and correct operation of equipment within the woodworking area. This is the authorization class for the area and is required prior to using the equipment. Safe practices will be demonstrated and learned by a hands on approach in the context of taking rough lumber through the process of milling and operation of all equipment in the space. If you have previously paid and attended a wood authorization class then we encourage you to audit the class free of charge at any time.
Cost of the event is $19.96 and is for Knox Makers members only.
Inkscape for the Laser
Inkscape for the Laser
Inkscape is the primary vector graphics editor used at Knox Makers. In this secondary class, some useful extensions and processes common to the laser will be taught, including: - hatch fill extension - engraving raster images - node editing and tracing - figuring out slots and tabs Computers will be provided and a basic knowledge…
Milling 101 – Bridgeport Mill Tool Authorization
Milling 101 – Bridgeport Mill Tool Authorization
** Intro to Machining is a prerequisite class. You have to complete the Intro to Machining class before you can take the Milling 101 Class. **
In this class you will receive basic hands on experience in operating a Bridgeport Series I J-Head milling machine. During this 3 to 4 hour class, Billy will go over the basics of tramming the head of the mill, tramming the vise, edge finding, work holding and setup, drilling , side milling, and top/end milling operations. You will also learn the basics of the DRO (digital read out), the table power feed, and basic care of the mill. This is a tool authorization class and once completed you will be authorized to use the milling machine and Knox Maker members will receive a key need to operate the mill. Intro to Machining is a prerequisite class.
There will be a fee of $24.96 for members.. There will be a maximum of 4 spots of this class, and a minimum of 2 tickets must be sold. If the class minimum is not met 48 hours prior to class start time, the class we be canceled and all tickets will be refunded.
Inkscape for the Laser
Inkscape for the Laser
Inkscape is the primary vector graphics editor used at Knox Makers. In this secondary class, some useful extensions and processes common to the laser will be taught, including: - hatch fill extension - engraving raster images - node editing and tracing - figuring out slots and tabs Computers will be provided and a basic knowledge…