Skip to content

Views Navigation

Event Views Navigation

Featured Featured

Small Alterations or Mending with a Machine

Knox Makers - Fiber Arts 116 Childress St SW, Knoxville

It’s time to dig deeper into the mending pile. Make that pair of pants that are too short into capris or shorts or simply shorten some jeans with a machine…

$14.96 – $24.96
Featured Featured

Milling 101 – Bridgeport Mill Tool Authorization

Knox Makers - Machining 116 Childress St SW, Knoxville

** Intro to Machining is a prerequisite class. You have to complete the Intro to Machining class before you can take the Milling 101 Class. **

This is a hands on class and is subject to run over the allotted 4 hours. Please make sure your schedule is free accordingly.

In this class you will receive basic hands on experience in operating a Bridgeport Series I J-Head milling machine. During this 3 to 4 hour class, Billy will go over the basics of tramming the head of the mill, tramming the vise, edge finding, work holding and setup, drilling , side milling, and top/end milling operations. You will also learn the basics of the DRO (digital read out), the table power feed, and basic care of the mill. This is a tool authorization class and once completed you will be authorized to use the milling machine and Knox Maker members will receive a key need to operate the mill. Intro to Machining is a prerequisite class.

There will be a fee of $24.96 for members.. There will be a maximum of 4 spots of this class, and a minimum of 1 tickets must be sold. If the class minimum is not met 48 hours prior to class start time, the class we be canceled and all tickets will be refunded.

Scroll To Top