Machining 100 – Intro To Machining
Knox Makers - Machining 116 Childress St SW, KnoxvilleBilly will give you a basic introduction to the machining area. This class will begin with a tour of the machining area with a, in-depth discussion of each tool, it’s uses, proper procedures, and safety. At the end of this class, all participating members will be authorized to use the drill press, box pan brake, handtools, and the horizontal bandsaw. **This is a prerequisite for the Bridgeport Mill and Lathe tool authorization classes**
There will be a fee for this class of $9.96 for current Knox Makers members. There will be a maximum of 8 spots for this class, and a minimum of 3 tickets must be sold. If the class minimum is not met 48 hours prior to class start time, the class will be canceled and all tickets will be refunded.
Project Lathe: Workday
Knox Makers - Machining 116 Childress St SW, KnoxvilleCome help clean, tune and get the new 13x40 MSC lathe up and running. We purchased a new to us lathe which requires a little maintenance before it's ready to use. This is a good opportunity to see the insides of a lathe and learn a bit more about them.